Documentation
  • Welcome
  • 🚀Getting Started
    • Introduction to AstroPlant
  • 🌱AstroPlant Kit Setup
    • Welcome to the setup guide
    • Designing your project
    • Operation & safety
    • Building the Maker Kit
      • Electronics assembly [Maker Edition]
      • Electronics assembly from scratch
      • Casing assembly v5.2
      • Extension shield connection mapping
    • AstroPlant software
      • Kit software setup
      • Building your kit software from scratch
      • Updating your kit software
      • Changelog
    • Registering and configuring a kit
    • AstroPlant Growth Protocol
    • Resources
    • Setup FAQ
  • ⌨️ Developers
    • Become a space dev!
      • AstroPlant Ecosystem
      • Data Concepts and Terminology
      • Software Architecture
      • GitHub Repositories
    • Core API
      • Getting Started
      • API Models
      • Live Feeds (WebSockets)
    • Community Platform
      • Architectural Decisions
      • Documentation
        • Project Structure
        • Front-End
        • Back-End
      • Development Setup
      • Roadmap
    • Software Customization
      • Use cases
    • Developers FAQ
  • 📚Resources
    • Contributing
Powered by GitBook
On this page

Was this helpful?

  1. 🌱AstroPlant Kit Setup
  2. Building the Maker Kit

Casing assembly v5.2

Building instructions for kit version 5.2

3MB
Astroplant Kit v5.21_building instructions.pdf
pdf
481KB
InstructionOnl'Faitcasing.pdf
pdf

You should use the Astroplant Onl'Fait casing if your laser cutter is smaller than 100cm x 70cm

PreviousElectronics assembly from scratchNextExtension shield connection mapping

Last updated 4 years ago

Was this helpful?